喷气纺的条子制备

新纺纱系统的研制开发与传统纺纱工艺的进一步发展都需要对技术要求和经济效果进行反复准确的分析。由于喷气纺的推广，尤其是在美国的推广使用，Rieter公司对此工艺的原材料的最佳准备状态进行了研究。本文即为Rieter公司纺织技术专家所完成的这方面大量研究工作的一个概述。     

高压水射流粉碎原盐

高压水射流粉碎技术是近年发展起来的一项新型粉碎技术。文中介绍了水射流粉碎机理和新研制的后混合靶式水射流粉碎装置 ,并通过原盐粉碎实验证明 ,水射流粉碎具有效率高、工艺简单、产品粒度可调等特点 ,是一项具有良好发展前景的粉碎技术。     

淹没水射流空化初生的动力判据

传统的空化初生判据没有考察空泡动力效应的影响和空泡的非等温过程，通过对Rayleigh-Plesset方程的适当无因次化，建立了一种既考虑空泡的动力学效应又适合各种绝热指数的简便的空化初生动力判据。计算了不同环境压力对空化初生的影响。     

静止浅水环境中铅垂紊动射流的试验研究

对静止均匀浅水域中的铅垂紊动射流进行了试验研究，得到了水面的隆起高度与射流出口单位能量和相对水深的函数关系，验证了隆起高度满足高斯分布，具有自相似性，并给出了统一表达式；借助于三维测速仪，得到了射流中心平面流场，结果表明射流中线流速的衰减比自由射流为快，随着射流出口流量的增加，射流出口处涡量亦增大。     

Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.     

工程监理取费偏低,阻碍监理行业发展

工程监理制在我国建筑市场中，对提高工程质量、控制投资效益起着极其重要的作用，目前我国工程监理行业在低取费的条件下，困难重重，只能维持低水平运行。我们应找出存在的差距，采取相应的措施，适当提高监理取费，使监理行业迅速发展壮大。     

Measurements of turbulent mass transport of a circular wall jet

The results of a laboratory investigation on the turbulence characteristics of a circular three-dimensional turbulent wall jet are presented. Measurements were taken up to 50 nozzle diameters using combined particle image velocimetry and planar laser induced fluorescence. The results showed that the induced turbulence was still evolving in the present range and had not achieved similarity. While the turbulent intensity for both velocity and concentration increased downstream, the turbulent mass transport showed a decline over distance for both the streamwise and spanwise directions, implying weakening dispersion from the jet core.     

横流均匀环境中三维线源型正负浮力射流特性研究

本文利用混合有限分析法及交错网格。对横流均匀环境中三维线源型正负浮力射流及负浮力射流的特性进行研究，分析了不同工况下流速，温度和湍动能在断面上的分布及影响射流轨迹线的因素，讨论了轨迹线上温度的变化及浮力射流的贴壁现象。对三维长线源型负浮力射流，分析了流速比，喷口弗汝德数对负浮力射流的影响。     

成藏流体历史分析——以黄骅坳陷三马地区为例

应用储集层岩石烃类流体包裹体研究方法，对黄骅坳陷三马地区沙一段油藏进行了重建成藏流体历史的尝试。对包体流体状态的分析表明，成藏流体具有高密度，高矿化度的性质，被捕获时的温度约为110－140℃，成藏流体的主要充注时期在明化镇组沉积期，距今为10－4Ma之前，充注成藏后的小幅度构造抬升中可能使原称油水界面以下的地层水矿化度发生变化，导致现今储集层流体矿化矿比包裹体流体矿化度明显下降。图5表2参6（钟宁宁摘）。     

热释电系数的测量方法

描述热释电系数的两种测量方法。其一为电荷积分法，测试系统简单，测量数据准确，且能满足零电场条件下的测量。其二为动态电流法，采用调制热源技术，研究在特定温度条件下热释电材料的动态热释电响应。